“V” Blocks
Material: Alnico 5
“V” blocks are ideal for holding cylindrical and complex workpieces for marking, spark erosion, grinding and measurement operations. Can be used on its base, side or end.
Top “V” maximum diameter: 65mm / 12.56”
Bottom “V” maximum diameter: 20mm / 0.79"
Tolerances
Parallelism: 0.0025 per 100mm I 0.0001" per 3.937"
Squareness: 0.025 per 100mm / 0.001” per 3.937"
(Tighter tolerances available)

Chuck Blocks
Supplied in matched and numbered pairs. May be used horizontally or vertically. Can be machined to accommodate awkward workpieces. Can be used to extend the flux paths of a magnetic chuck with parallel poles.

Table Top Demagnetizer
Lightweight units for the removal of residual magnetism from components after workholding. CE approved. (Maximum usage: 2 minutes in any 4-minute period.)

Simple Sine Table Series: SSTFP

Applications:
Highest quality sine tables for precision grinding and spark erosion. Neodymium (rare earth) magnet system provides strong clamping force.

Standard features:
• Pole pitch 0.5mm brass / 1.4mm steel
• Tilts on longitudinal axis
• Maximum precision
• Very low height
• Tilt range 0-45 degree
• Angular accuracy: plus / minus 5 sec.
• Baseplate thickness at 0 degrees = 3mm
• Plane parallelism plus / minus 0.005 / 100mm

Supplied with:
• Wooden box
• Sine conversion table from degrees / minutes to mm