Receiving Belt Magnet - MPI Magnet

MPI’s Receiving Belt Magnets remove both large and small types of tramp metal from product streams conveyed by belts at speeds up to 250 feet per minute. The captured tramp metal accumulates across the entire magnetic face, substantially increasing the amount of tramp iron the magnet can retain before cleaning is required.

Complete Application Form for Quote

MPI’s RBM magnet consists of a large plate magnet suspended over the conveyed product stream. The Receiving Belt Magnet should be suspended approximately 5” - 8” above the product stream for optimum tramp metal removal (8”-10” with bucking option). The magnet should be located in an area that has easy access to allow for proper cleaning. Also, the magnet should operate in an area of the belt where no integral parts of the conveyor can become magnetized, such as idler rollers or belting support plates, as this may cause excessive wear on the conveyor system. To clean the magnet, simply grab the handle on the quick clean stripper and pull towards you until it hits stop. After all metal has fallen from the stripper, slide the stripper face back into place.

  • Permanent ceramic 8 magnet will not demagnetize, create heat or require electricity to operate
  • Stainless steel enclosed magnet
Receiving
Belt Magnet Model #
Belt Width
Magnet Width
Approximate
Weight
IN
CM
IN CM LBS KG
RBM-18 24 61 18 46 950 432
RBM-24 30 76 24 61 1300 691
RBM-30 36 91 30 76 1600 727
RBM-42 42 107 36 91 1900 864
RBM-48 48 122 42 107 2300 1046

 

  • Self-cleaning models
  • Custom support frames
  • Heavy-duty sanitary design support frame
  • “Buckling Magnet” configuration for enhanced strength and reach out, resulting in a performance increase of approx. 25%

How can MPI help?

Please let us know your name.
Please write a subject for your message.
Invalid Input
Please let us know your email address.
Invalid Input
Invalid Input
Invalid Input
I’m a real person
Invalid Input
Invalid Input